Compatible replacement brush and filter maintenance kit for iRobot Roomba 600 series robot vacuum cleaners

This compatible replacement accessories kit is designed for iRobot Roomba 600 series robot vacuum cleaners and replaces commonly worn maintenance components including the dual main roller brushes, edge sweeping side brushes and AeroVac filtration system. Over time these components accumulate dust hair and debris which can reduce suction airflow and cleaning efficiency. Installing fresh replacement parts helps maintain consistent suction performance, reliable debris pickup and effective edge cleaning across carpets and hard floors.

How replacing brushes and filters helps maintain Roomba cleaning performance

Robot vacuum maintenance parts gradually wear during normal cleaning cycles. Roller brushes lose their ability to agitate carpet fibres and lift debris effectively from floors. Side brushes may become bent which reduces corner sweeping efficiency. Filters also become restricted as fine dust accumulates in the filtration media. Replacing these components restores airflow through the vacuum system and helps maintain consistent cleaning performance.

Replacement kit contents

• Dual main roller brushes designed to agitate carpets and lift dust hair and debris from hard floors
• Three AeroVac compatible high efficiency filters designed to capture fine dust particles while maintaining airflow
• Two spinning side brushes designed to sweep debris from corners edges and along skirting boards toward the suction inlet
• Three mounting screws for installing replacement side brushes

Compatible robot vacuum models

This compatible replacement accessories kit is suitable for the following iRobot robot vacuum cleaners.

• Roomba 600
• Roomba 620
• Roomba 630
• Roomba 650
• Roomba 652
• Roomba 660
• Roomba 680
• Roomba 690

Compatibility platform reference

The robot vacuum models listed above share the same brush chamber design, AeroVac filter housing and side brush mounting system used across the Roomba 600 platform. This allows the roller brushes, filters and side brushes included in this kit to install correctly within the cleaning system used by these models.

Installation instructions

• Turn off the robot vacuum and remove it from the charging dock
• Turn the robot upside down and remove the brush guard cover
• Remove the worn roller brushes and insert the replacement brushes into the brush chamber
• Remove the worn side brush and install the new side brush using the supplied mounting screw
• Remove the dust bin and open the filter compartment
• Remove the used AeroVac filter and insert the replacement filter
• Reinstall the dust bin and close the brush guard cover
• Restart the robot vacuum and run a short cleaning cycle to confirm correct installation

Recommended replacement intervals

• Side brushes should generally be replaced every three to six months depending on cleaning frequency
• Filters should be replaced every two to four months to maintain airflow performance
• Roller brushes should be replaced every six to twelve months depending on wear and hair accumulation

Routine replacement helps maintain consistent suction performance and cleaning efficiency.

Frequently asked questions

• Q. How often should Roomba filters be replaced
  A. Filters should generally be replaced every two to four months depending on dust levels and cleaning frequency.
• Q. Why do Roomba roller brushes wear out
  A. Roller brushes gradually wear as they agitate carpets and collect debris which reduces cleaning efficiency.
• Q. Can clogged filters reduce suction performance
  A. Yes clogged filters restrict airflow which can reduce suction and dust collection performance.
• Q. Are these parts compatible with all Roomba models
  A. No this kit is designed specifically for Roomba 600 series models listed in the compatibility section.
• Q. Do side brushes help clean corners
  A. Yes side brushes sweep debris from corners and edges toward the robot vacuum suction inlet.

Technical specifications