HYTRONIK HRC-11 Settings Remote Control

A simple to use Hytronik remote Control for programming a range of the Hytronik Sensors.

Permanent ON/OFF function Press button “ON/OFF” to select permanent ON or permanent OFF mode. * Press button “AUTO”, “RESET” to quit this mode. The mode will change to AUTO Mode after power failure.

Reset Settings Press button “RESET”, all settings go back to factory default settings. Hold-time: 5min, daylight threshold: 2lux 

Shift Button Press button “Shift”, the LED on the top left corner is on to indicate mode selection. All values / settings in RED are valid for 20 seconds.

Auto Mode Press button “AUTO” to initiate automatic mode. The sensor starts working and all settings remain as before the light is switched ON/OFF. Note: the function of Semi-auto is disabled

Scene program - 1-key commissioning 1. Press button “Start” to program. 2. Select the buttons in “Daylight threshold”, “Hold-time”, “Stand-by time”, “Stand-by dimming level” to set all parameters. 3. Press button “Memory” to save all the settings programmed in the remote control. 4. Press button “Apply” to set the settings to each sensor unit(s). For example, to set daylight threshold Disable, hold-time 5min, the steps should be: Press button “Disable”, “Shift”, “5min”, “Memory”. By pointing to the sensor unit(s) and pressing “Apply”, all settings are paused on teh sensor(s)

Daylight threshold Press buttons in zone “ Daylight threshold” to set daylight sensor at 2Lux/ 10Lux / 50Lux / 100Lux/ 300Lux/ 500Lux or Disable. 

Ambient daylight threshold1. Press button “Shift”, the red LED starts to ash. 2. Press button “Ambient”, the surrounding lux level is sampled and set as the new daylight threshold. 

Hold-time Press buttons in zone “hold-time” to set the hold-time at 2s / 30s / 1min / 5min / 10min / 15min / 20min / 30min. Note: 1. To set hold-time at 30s / 5min / 15min / 30min, press “Shift” button rst. 2. 2s is for testing purpose only, stand-by period and daylight sensor settings are disabled in this mode. *To exit from Test mode, press button “RESET” or any button in “Hold-time