Will these skirts interfere with jack point access?

The W-1 profile is designed with factory mounting integration in mind. Before installation, verify that your OEM service jack points remain clear by test-fitting the skirts. If your vehicle uses pinch welds or side rails for service jacks, measure your jack placement and mock up the skirts before final mounting.

Do I need to prime and paint these before bolting them on?

Yes. These ship in raw FRP condition — bare FRP gelcoat. Sand the surface to prepare it, apply primer, and then your choice of base coat and clear. This allows you to match your vehicle's exact color and finish rather than installing pre-painted parts that may not align perfectly.

What fasteners or adhesive do I need for installation?

This set is designed for bolt-on installation at factory rocker mounting locations. You'll need to source fasteners appropriate to your vehicle's OEM holes — reference your service manual or OEM parts diagrams for the correct fastener size and torque specs. Do not use adhesive alone; bolts are required for structural integrity.